News:

Hi!

Welcome to my DIY audio forum. The forum SW has been reset and unfortunately there were some problems with backup files so a few posts were lost, nothing important though.

Cheers
Per-Anders Sjöström

Main Menu

SST01 R1 and LED Questions

Started by westers, January 11, 2016, 09:24:30 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

westers

Hi

What is the purpose of R1 - is it for limiting current inrush?

I have an insulated LED that is rated for 1.7VDC, and a forward current of 20 ma; I am confused on what values to use to work out the resistor value of R2 to allow the LED to operate. (I know V=IR, but I don't know what value of V to use (1.7VDC, or 230 VAC), or what value of I to use.

Thanks

perandersSMF

R1, yes

You can estimate the resistor to 1.7V/20 mA = 85 ohm, 82 or 100 ohm maybe-
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

westers

Thanks.

Can you explain the theory behind that - why those values are chosen instead of the supply voltage of the circuit and the 47ma current that is on those rails (from a previous thread).  Electronics is not my speciality,  however I like to learn,  and google doesn't provide answers (it says to use (Vs - Vd) /I,  where Vs = supply voltage,  Vd= voltage drop,  and I = current required.  That equation is obviously no use in this context)

Thanks