Author Topic: QSXM2 questions.  (Read 3887 times)

0 Members and 1 Guest are viewing this topic.

Offline zz1969

  • Member
  • **
  • Posts: 6
  • Karma: +0/-0
  • Custom title, please change to something cool.
QSXM2 questions.
« on: March 07, 2013, 05:48:59 AM »
Hi P-A!
I need your advice on my final checking of my QSXM2.
The system is the following:
I ‘m using  15v supply with 2 x JSSR04; BC850/860C; LEDs (forward voltage 2.1v, current 20 mA) – 1863179 – Farnell code
1.   MM cartridge (Ortofon 2M Blue):  47K, 150-300 pF – Should I change C1 to 300 pF?
2.   IC5, IC6 - TEXAS INSTRUMENTS - OP07CP - IC, OP AMP, LOW OFFSET, DIP8 – It takes up to 18v so I removed dz9/10 and C61/62. Is that right?
3.   Do I understand right that R2 should be 0 ohm if there’s no RF interference?
4.   I could’t find the correct LED so I used the LED above. There’s  1.85 v across the LEDs – do I need to change R42…47?
5.   Also I have some unbalance between Left and Right PreAmps: voltage across R33 – 1.35v E33 – 1.88v, R35 – 0.7v, E35 – 1.22v. I guess I heated too much some of the transistors. Where do you recommend to look?

Rgds,
Evgeny

Offline peranders

  • Administrator
  • Reached Nirvana
  • *****
  • Posts: 1230
  • Karma: +6/-0
  • Gender: Male
  • Forum owner
    • Sjöström Audio
Re: QSXM2 questions.
« Reply #1 on: March 07, 2013, 06:24:13 AM »
  • Deside yourself.
  • Yes
  • Yes
  • No, unless it gets too hot but you got almost the same as I!
  • This will be take care with the feedback. NPN and PNP devices aren't 100% the same.
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

Offline fantast

  • Member
  • **
  • Posts: 20
  • Karma: +0/-0
  • Custom title, please change to something cool.
Re: QSXM2 questions.
« Reply #2 on: October 08, 2013, 08:30:13 PM »
I would also recommend to go to 150pF. I did with my Ortofone MM and it gave the best result.