News:

Hi!

Welcome to my DIY audio forum. The forum SW has been reset and unfortunately there were some problems with backup files so a few posts were lost, nothing important though.

Cheers
Per-Anders Sjöström

Main Menu

Pre assembled SSR02 output voltage incorrect

Started by Simon, October 06, 2010, 09:30:11 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Simon

Hi Per-Anders

As per my email, the pre assembled LM329 SSR02 15V is outputting what appears to be an incorrect voltage. With an input of 24V, only 8V is being output.

My initial question was if the LM329 was installed correctly? It is in the top position and I am asking as it is not working correctly and from what I can deduce from the LM329 pinouts and the circuit diagram this could possibly be incorrect?

many thanks

Simon

perandersSMF

Are you sure you have connected it in the right holes? Do you still have tin blobs on the sense inputs (J1 and J2)?

8 V out indicates that the opamp isn't working.

- 24 V in = X1
GND = X8

-15 V out = X4
GND out = X2


Can you measure the voltages at the opamp pins?

The regulator did deliver 15.3 V when I tested it.
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

Simon

Yes, I will measure all of the opamp pins and get back to you. I have used the correct holes and the tin blobs are in place. I decided to test it on my bench power supply before installing in the DAC.