1
Power supplies / Re: H1 led value
« on: January 09, 2011, 01:12:16 PM »
Thank you!!
News:
I have moved the forum to an another web hotel and at the same time done some housekeeping. All zero-posters are removed. Feel free to register again.
Cheers
Per-Anders Sjöström
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Power supplies / Re: H1 led value
« on: January 08, 2011, 06:53:36 PM »
Yes, I'm using your values.
N1 pin2=6,78V
N1 pin3=6,78V
N1 pin6=11,74V
N1 pin2=6,78V
N1 pin3=6,78V
N1 pin6=11,74V
3
Power supplies / H1 led value
« on: January 08, 2011, 01:40:53 PM »
Yesterday I finished my SRR01 at 18V (328 +LT1028), but I measured it and I have 18'6V, will be a H1led problem?, my H1 is clear red and have 1,9V VF, is this correct?.
Best Regards
Best Regards
4
Power supplies / SSR01 use
« on: January 03, 2011, 09:54:39 PM »
heaveno,
I'm assembling a SSR01 at 18V for power up a Pass B1. My plans are do a bridge rectifier with a MUR102 diodes (With a 18V transformer) and will connect it to a SSR01, Need I filter this bridge before connect to a SSR01?, any suggestions?.
I'm using on the SSR01 a LM329 and a LT1028.
Best Regards
I'm assembling a SSR01 at 18V for power up a Pass B1. My plans are do a bridge rectifier with a MUR102 diodes (With a 18V transformer) and will connect it to a SSR01, Need I filter this bridge before connect to a SSR01?, any suggestions?.
I'm using on the SSR01 a LM329 and a LT1028.
Best Regards
5
Power supplies / BC556B instead of C on SSR01
« on: January 03, 2011, 09:27:20 PM »
heaveno,
Is possible use a BC556B instead of BC556C?
Best Regards
Is possible use a BC556B instead of BC556C?
Best Regards
Pages: [1]