News:

Hi!

Welcome to my DIY audio forum.

Cheers
Per-Anders Sjöström

Main Menu

SST03 LED voltage

Started by dvb-projekt, February 18, 2012, 04:13:59 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

dvb-projekt

Hi P-A,

the LED in my power-switch needs 12V. I measure only 0,46V at the LED connector X4.
Is the measured voltage normal with the resistor value from the BOM?

Any recommendations?

Best regards,
Oliver

peranders

You may adjust R2. If your LED can take approx. 40 mA, then you can omit the R2 but if it's too much you can let current go through R2. 560 ohms may be sufficient.
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

dvb-projekt

i have insert a pot to adjust the voltage to the needed 12V.
Run's perfect! :wink:

Best regards,
Oliver

peranders

Notice that this pot is on a deadly potential. I'll recommend that you change to a fixed value when you have adjusted the right current.
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff