News:

Hi!

Welcome to my DIY audio forum.

Cheers
Per-Anders Sjöström

Main Menu

JSR03, 7.5 volts out instead of 5 V

Started by peranders, July 24, 2009, 06:19:40 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

peranders

Which voltage reference do you use, LM431?

Voltage at pin 2, 3, 6 and 7 of the opamp?

DZ1 is a LED? Is it lit?
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

Bradley Kindell

Hi P-A,

I am using a TS431 voltage reference.

the OP-AMP has the following voltages on its pins

2 = 2.55v
3 = 2.55v
6 = 5.71v
7 = 7.31v

Brad

Bradley Kindell

i forgot I am using a red 140mcd led for DZ1 and both leds are lit.

peranders

#3
The sense connections are connected?

The pin 2 should have the output voltage divided by 2. Have you checked this voltage divider carefully? 1 k+ 1k

R12 mounted, R11 not mounted?
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

Bradley Kindell

R1 and R2 are both 1k

I have installed R11 as shown on the 5v parts list, although I thought that R12 would be needed on lower output voltage versions.........


Brad

peranders

/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

Bradley Kindell

no good.

just removed R11 and put R12 in place. Output still the same. Only difference now is that the Opamp is getting 10.5 volts via R12.

any other ideas?

the main LED is not as bright as the one used in the DZ1 position.

everything else is as per the BOM for the 5v output.

R10 is shown as a wire jumper in the BOM and also 470 ohms - I have fitted the wire jumper - is this correct?

Brad

Bradley Kindell

the sense inputs are shorted to the corresponding outputs - is this correct?

peranders

Since you have exactly the same voltage on pin 2 and 3, no short there? A close up photo could help me.
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff