Sjöström Audio DIY forum

Projects => Power supplies => Topic started by: gianluca on August 30, 2007, 04:05:24 PM

Title: QSXPS output
Post by: gianluca on August 30, 2007, 04:05:24 PM
Ciao everybody!

During my holidays I terminated my pre-phono (2xQSXPS+QSXM2). I'm really happy and satisfied, but I've a problem with the output of the two QSXPS.

It was impossible to obtaine more than ±11.2 volt from the outputs of the two QSXPS. The only solution that I've find  (temporary solution) it's to connect in parallel at the two R45-R47 (and R46-R48) a 2,2k resistor. Now with the 3 resistors is possible to regulate the output to ±18 volt.

What's do you think, where is my error?

Someone can help me?

[attachment deleted by admin]
Title: Re: QSXPS output
Post by: peranders on August 31, 2007, 06:36:10 AM
If you have a 5.00 volt reference voltage at IC3 and to the input of IC1, pin 5. That's correct. If only R43, 45 and 47 are mounted you should get 15 volts out. R49, P1 is an option if you want to trim the voltage but the values must be calculated so you'll get the right trim range.

If you want 12 V R43 should be 3.9k.

(3.9/(5.6//5.6)+1)*5 = 12

// = in parallel