Hi Again Per-Anders,
Got the Board...looks as good as i expected, got components from Digi-Key and RS Components.
Anyway, i have some questions, some quite basic but i want to do it right, here goes:
I'm doing it as +-12 v, i want 1A output or more but not necessary.
1 - Got Panasonic LC series 100 microF , Nipon Chemi Con KMH series 4700 MicroF main caps...are these OK ?
2 - Input rectifier, do need to put 1N5407 in parallel with 1N 4007 or are you indicating an option ?
3 - I notice that you do not include the POS POST PRE-Regulator in your board ( Picture on site ), why is that, should i do this as well ?
4 - You have a zero ohm link in place of the 100 ohm resistor R49....why ? which sould i put in ?
5 - You do not include C37, I also use the AD825AR, should i ?
Excuse all the questions but i don't want to ask even more later....hehe
NOTE:I Got the components from Digikey because if we order from the european interface we do not pay import duties...very usefull and mailing cost is cheaper for me than ELFA....components are also much cheaper and delivery is FAST.