Projects > Power amplifiers
QRP02 DC out
AudioSpirit:
I installed r19 and r20 not correct.Moved them to other direction.First chanell is fixed,but second still doesn't work.I work on it right now,hope I've not burned lm3886:)
AudioSpirit:
Ok,I fixed all.On second board was bad Ad8620 .I replaced ic and now all is ok.
AudioSpirit:
Actually I like AC level ,it is 0,000V now,under my Fluke 112 measurement level.Unbelivable!
Actually all will be bilded in dual monoblock design inside of Technics SA900 body and hope will looks extremely attractive.Will post more details later.
peranders:
You will probably experience 0.02-0.08 mV(!) offset. Good to hear that you managed to get it working... I suppose you didn't build as a wrote in the instructions. It's smart to build and test piece by piece just because SMD is a bit harder to troubleshoot.
So fix first the PS and +- 12 volt, then the IC1 and last the LM3886.
AudioSpirit:
Ooops.I awake today,bringed amp up und... BUMMM from speakers.I fast disconnected speakers. ad8620 died. I replaced to other now it is again working.But here one dangerous thing which I like to fix.
Here is no defence against AC from IC 1.Can I replace r6 1 kOhm with capacitor? Even tought about I can burn my loudspeakers make me very nervous...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version