News:

Hi!

Welcome to my DIY audio forum.

Cheers
Per-Anders Sjöström

Main Menu

QSXPS - weird output voltage

Started by Olivier M., December 14, 2008, 09:48:55 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Olivier M.

I get 7.6V out of both output rails of the QSXPS. (with R43 - R49 and P1 are soldered on the picture but R49 has one pin lifted)
Looking back at a preview topic, I checked several voltages and they all look right.

V(IC3)=5V
V(IC1-pin5)=5V

Vout Unstab = 29V

I have attached a picture of the positive side of the board in case there is something obvious that I missed.

Any idea? What other voltages can I check?

Olivier

[attachment deleted by admin]

peranders

#1
R29, which value? Red-Red-Red is normally 2k2 instead of 2R2 ohms.

You should not have all resistors fit in the feedback, at least this was not my intention.

Which output voltage do you want?
/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff

Olivier M.

You have a good eye. This is the faulty value!
I had checked all other values but left this one.
I swapped it with a 2.2 ohm resistor and I now get the desired 15 volts.
Thanks

peranders

/Per-Anders Sjöström, owner of this forum

Homepage with my DIY hifi stuff