Test

If you don't plan to use the "sense" function, put a tin blob on the solder side at J1, J2, J3 and J4 (see the schematics also).

  • Use a regulated power supply and set the current limit to 50-100 mA or something low.
  • Connected a voltmeter at the output.
  • Turn up the voltage slowly and observe the output and the current consumption. When the LED H1 starts to shine you should have a stable output voltage.
  • Add a load to check is the voltage still is stable including some warm-up of the opamp and the voltage reference (a few millivolts).

If you have the pre-regulator LM317 installed the output voltage should be stable with 4-5 volts more in than set output voltage.