Circuit description

The design consists of two independent sections, one positive regular with a LM317 as the main part. The other half is a negative regulator with a LM337. The design is taken more or less directly from the datasheet of the LM317 and the  LM337

 The positive half

The transformer is fused with 63 or 100 mA fast, 5 x 20 mm, European type. R9 is a varistor for transient protection. For 115 VAC this part must have a suitable value, from 150 VAC. The size should be K20.

The transformer type is 1.5-2.3 VA and the output voltage should the same as the wanted output voltage. 15 VDC out requires a 15 VAC transformer but this rule is only valid for > 10 V out. For lower voltages you must have enough raw voltage. For 5 volts out you must see to that there is 5 volts across the LM317 in order to have a good regulation.

C1 is for EMC and RFI reasons. The value is not critical but not more than 220 nF.

C2 is for smoothing and is always a tradeoff between losses in the transformer and a smooth raw voltage with maximum output current.

R1 is a bleeder resistor and is for disharging C2. Some loads requires zero volts for complete reset and it is also good to have zero volts out if you happend to connect something. The risk of damaging the load is less. The value of the bleeder is a tradeoff between increase of voltage ripple, power dissipation in the resistor and the discharge time.

D1 is a rectifier bridge which should be 1 A at least and 100 V, otherwise it's not critical.

D2 is a protection for the regulator if you connect voltage at the output with having the power supply powered up.

D3 protects the LM317 if you happen to short the output and the C4 is more than 25 uF.

D4 is a protection for applied voltage at the output with reversed polarity.

IC1 is a LM317 but you can use pin compatible parts. LM317 is  chosen because it's easy to get.

C3 is normal decoupling for the LM317. Value is not critical.

C4 decreases the output impedance, specially noticed for higher output voltages. For 3.3-5 volts is this cap not very important.

C5, C6 is for stability reasons of the LM317.

R2-R4 determines the output voltage. R3 is for trimming reasons. It's easier to get the right voltage if you have the possibility to have two resistors in  parallel.

The output voltage

Uout = 1.25*((R2/(R3//R4))+1) See the datasheet for calculating the output voltage.

I have made a Excel file for calculating the output voltage. The file is "quick and dirty" right now.

The negative half

The negative half is the same as the positive except for the LM337 instead of the LM317.

The negative half with a positive output voltage

If you if some reason want to have two positive output voltages you can achieve that doing this:

  • Don't mount IC2
  • Mounting IC3 with a LM317
  • Rotate D5 180 degrees. The minus pin should be in the plus hole.
  • Rotate C8, C10, C12, D6-D8

Don't forget to tie the grounds together if you don't want separated output voltages.